D-tek vehicle loop detector manual

D-TEK™ Operating Instructions 9 Document no. Installation 1. Connect the D-TEK to appropriate power supply as marked on the label of the detector on pins 1 and 2 according to the connection chart on page 3 of this manual. 2. Connect the loop wires to pins 7 8 (Brown and Gray wires in harness) The D-TEK must be. 1. Connect the D-TEK to appropriate power supply as marked on the label of the detector on pins 7 and 8 according to the connection chart on page 3 of this manual. 2. Connect the loop wires to pins 9 10 (Brown and Gray wires in harness) The D-TEK PCB-1 must be connected to a loop meeting the appropriate requirement listed on page 2. 3. In general, loop vehicle detectors from all manufacturers work under the same principle and will all work reliably if the installation is done properly and the correct materials are used. Vehicle detector features differ between manufacturers, and most are straight forward. The following features need special Missing: d-tek.

The EMX Ultra II D-TEK Vehicle Loop Detector was designed to be a more compact, energy efficient, cost effective and reliable detector that is easier to install and setup. Sensitivity selection is simplified by the ULTRAMETERTM display that indicates the appropriate sensitivity setting to detect the vehicle positioned on the loop. Microsoft Word - MVP_D-TEK Operating Instructions Rev 1. Connect the D-TEK to appropriate power supply as marked on the label of the detector on pins 1 and 2 according to the connection chart on page 3 of this manual. 2. Connect the loop wires to pins 7 8 (Brown and Gray wires in harness) The D-TEK must be connected to a loop meeting the appropriate requirement listed on page 2. 3.

The primary function of the detector is to detect vehicle presence by means of an inductance change caused by the vehicle passing over a wire loop buried. EMX Industries Inc. has designed the MVP D-TEKTM for applications where vehicle detection is needed. MVP D-TEKTM makes it simple to manage your stock. All you. If you are not sure which voltage you need to install a gate or garage door opener, the answer lies with the North Shore Commercial Door MVP.